I have a Eureka Bag less vacuum and it was working ok up until last night. I noticed that the container was full, so I emptied it, and then I noticed it wasn’t sucking up much stuff, so I cleaned out the roller and then noticed this little panel at the bottom and saw that there was stuff clogged in there, so I emptied that stuff. I started vacuuming again and noticed that not much stuff was getting vacuumed up. Then I looked at the bottom again, and noticed that there is stuff trapped in that little panel again. Can someone help me figure out what is going on?
That little panel is probably a filter and it is getting clogged up with stuff below it. If you take the filter out you might be able to clean out below it or maybe you can get to it from below. Take the beater out and clean out that area. If you can’t figure anything else out, you could take it outside, take the filter out and with it open run it to see if you can get all the debris out of it. You will probably have to wipe it clean after this but it will probably get you going again.